We service both gas and electric furnace systems with manufacturer-trained technicians.
Heat exchanger cracks, ignitor failures, and gas valve issues all fall within our scope.
If you're dealing with a pilot light that won't stay lit, an ignitor that clicks but never catches, or a furnace that runs but blows cold air, you already know furnace failures carry a safety dimension — carbon monoxide and gas leaks — that most other HVAC repairs don't, so the diagnostic has to start there.

AAA Pro HVAC built its furnace repair process around one idea: diagnose first, quote honestly, fix it right.
Every truck across Cabool, MO carries the tools and common parts specific to furnace repair, so most calls finish in a single visit.

Cracked heat exchangers get flagged immediately as a safety issue, not just a repair line item.
Our crews are trained on standing pilot, hot surface ignition, and electric resistance furnace systems alike.
No push toward replacement when a repair genuinely solves the problem.
No-heat calls during freeze warnings get moved to the front of the schedule.
Every job starts with a real diagnosis, not a guess — here's the full scope of what our furnace repair technicians handle across Cabool, MO.
Standing pilot systems get checked for thermocouple failure, the most common cause of a pilot that won't hold. This is one of the most requested furnace repair calls we get across Cabool, MO.
Faulty gas valves are treated as a safety-critical repair, prioritized accordingly. Techs handling gas valve diagnostics carry the specific parts and tools this job calls for, not a generic kit.
We use a combustion analyzer and visual borescope inspection, not guesswork. Techs handling heat exchanger inspection & repair carry the specific parts and tools this job calls for, not a generic kit.
We test motor amp draw against rated spec before replacement. Techs handling blower motor & limit switch repair carry the specific parts and tools this job calls for, not a generic kit.
We inspect the full flue run, not just the connection at the furnace. Techs handling flue & venting repair carry the specific parts and tools this job calls for, not a generic kit.
We test low-voltage circuits before condemning the board. Techs handling thermostat & control board diagnostics carry the specific parts and tools this job calls for, not a generic kit.

Tell us the symptom — no ignition, cold air, gas smell, or error code — and we route accordingly.
Techs arrive with combustion analyzers and common ignitor/gas valve stock loaded.
Safety check first — combustion and carbon monoxide — then full mechanical diagnostics.
Most ignition and control repairs finish same-visit.

Furnace kept clicking like it wanted to light and never catching.
Old furnace was blowing cold air even though the blower ran fine.
They found a hairline crack in the heat exchanger I never would've noticed.
Thermocouple was the culprit, replaced and tested before the tech left.

A clicking-but-not-lighting pattern is one of the most common furnace complaints we diagnose.
Yes — it's a genuine carbon monoxide risk and we treat it as a safety issue, not a routine repair line.
This symptom shouldn't be ignored since it sometimes points to a safety-related fault.
Electric resistance furnaces fail differently than gas units, and we diagnose accordingly.
Immediately — leave the area and call, don't attempt to diagnose it yourself.
Call dispatch for a live arrival estimate based on current demand.

Our furnace repair crews are positioned throughout Cabool, MO to keep response times realistic, not just promised.
☎ Call +1-844-611-2875 for Cabool Service